Last updated: 2026-11-18
Every taphole machine we build is designed to one furnace. There is no catalogue rating to compare, so this page sets out the ten parameters that decide the design, which side controls each one, and the design envelope from JB/T 14772-2024.
Ten design drivers
| Parameter | Design envelope | What determines it | Who provides |
|---|---|---|---|
| Clay barrel capacity | up to 120 L | Hole diameter × hole depth × clay per tap × taps per day | Client gives hole size; we size the barrel |
| Clay delivery rate | 3.7 L/s | Tapping cycle time — plugging must finish within the cycle | We design to the cycle |
| Drilling depth | up to 1,500 mm | Wall thickness at the taphole | Client (furnace drawing) |
| Hole diameter | 40 – 100 mm | Metal flow requirement, clay strength, bit size | Client (process) |
| Drilling rotation torque | up to 500 N·m | Clay hardness and hole diameter | We design |
| Drilling impact frequency | up to 50 Hz | Rock drill selection, wall thickness | We design |
| Poking and pulling force | up to 7 kN | Whether the metal channel must be cleared online | Client (process) |
| Hydraulic system pressure | 13 MPa rated | System standard | Standard |
| Compressed air pressure | 0.6 MPa | Plant utility supply | Client |
| Air consumption | up to 8 m³/min | Rock drill selection and impact frequency | We design |
Values marked “up to” are the limits set in JB/T 14772-2024 §4.2 for this class of machine. A specific machine is normally built inside those limits, to the furnace it serves.
The four things that change most between projects
Mounting arrangement. Floor-rail, slewing-arm or suspended. Decided by platform load capacity, available space, and how many tapholes the machine must reach from one parking position.
Drilling unit drive medium. Pneumatic, hydraulic or air-hydraulic. Decided by whether the plant has a reliable compressed air supply, what power costs, and what maintenance skill is available on site.
Control method. Manual multi-way valve, local push-button, wireless remote, or integration with the plant control room. Decided by the safety distance the plant wants between operator and taphole.
Poking and pulling unit. Fitted or not. Usually fitted where the slag and metal separate poorly and the channel has to be cleared while the furnace is running.
What we need from you to propose a machine
- Furnace type and rated capacity in kVA
- Number of tapholes and their elevation above the operating floor
- Taphole wall thickness and hole diameter
- Tapping cycle: taps per day and time available per tap
- Platform load capacity and available footprint
- Compressed air pressure and flow available at the interface point
- Power supply: voltage, frequency, phases
- Control method required and any plant-level interface
With these eight values we can propose an arrangement drawing. Without them, any quotation would be guesswork.
Why we do not publish a fixed specification
A supplier who quotes you a fixed rating has not yet looked at your furnace. Taphole wall thickness sets the drilling depth. Hole diameter and tapping frequency set the clay capacity. Platform load decides whether the machine is floor-mounted or suspended. None of these are the same twice.
Frequently asked questions
Can I use a machine built for another furnace?
Only if the taphole geometry, cycle time and platform arrangement match. Mounting and travel are the parts that most often cannot be re-used.
How long does a custom design take?
It depends on how many of the eight inputs above are already fixed. We will give a schedule with the technical proposal rather than before we have seen the furnace data.
Do you publish drawings?
Assembly drawings, foundation loads and interface positions are issued as project documents under the contract. We do not publish customer-specific drawings on this site.
Design envelope per JB/T 14772-2024 §4.2. Ocean Hydraulic drafted this standard.